|
PoE-G2448 Single Port 24V 48W GIGABIT Power Over Ethernet Adapter Features • Compliant with Isolation and Channel
• Data and Power carried over one Ethernet Cable
• DC Good LED • Full Protection- OCP, OVP
• Non-Vented Case Applications • IP Telephones • Security Camera
• Wireless Network Access Points • IP Print Servers
• Blue Tooth Access Point Safety Approvals • CE Mechanical Characteristics • Length: 123mm • Height: 40mm • Width: 61mm • Weight: 0.2Kg This Power over Ethernet Injector provides DC 24V over Ethernet cables. This Gigabit Power over Ethernet Injector inserts DC Voltage into Cat.5 cable allowing the cable between the injector
and PoE Ready Device to transfer data and power simultaneously. The maximum distance between the injector and PoE Ready Device is 100 meters. Unlike the existing Power over Ethernet Injector, it also provides 10/100/1000Mbps Gigabit Ethernet connection ability. The PoE-G2448 is perfect PoE Injector for PoE ready 802.11n Wireless Access Points. 802.11n has maximum of 300Mbps bandwidth under best condition. 802.11n will operate around 130Mbps under normal condition. Only PoE-G2448 can provide both the bandwidth and power for 802.11n Wireless Access Points. INPUT:
AC Input Voltage Range EMC
90 to 264VAC FCC Part 15 Class B
AC Input Voltage Rating EN55022 Class B
100 to 240VAC Isolation Test
AC Input Current Primary to Secondary: 3000VAC for 1 minute 10mA
0.5A(RMS) max. for 90VAC Primary to F.G.: 1500VAC for 1 minute
0.35A(RMS) max. for 240VAC Output to F.G.: 1500VAC
Leakage Current Immunity EN50082-1
0.25mA max. @ 254VAC 60Hz ESD: EN61000-4-2. Level 3
AC Input Frequency RS: EN61000-4-3. Level 2
47-63Hz EFT: EN61000-4-4. Level 2
AC Inrush Current Surge: EN61000-4-5. Level 3
15A(RMS) max. for 115VAC CS: EN61000-4-6. Level 2
20A(RMS) max. for 230VAC Voltage Dips EN61000-4-11
OUTPUT: Harmonic: EN61000-3-2
Total Output Power Insulation Resistance
48W Primary to secondary: >10M OHM 500VDC
Efficiency Primary to FC: >10M OHM 500VDC
80% (typical) at Max. load, and 120VAC 60Hz FEATURE:
Hold-up Time Over Voltage/Current, Short Circuit Protection
16mS min. 120VAC and max. load The output can be shorted permanently without damage
Transient O/P Voltage Protection Indicators
30V max. at switch on and off at any AC line Phase Led #1 indicator for input power “on” GREEN
ENVIRONMENTAL: Input Connector
Temperature IEC320 inlet 3 pin
Operation -10 to +50°C Data Connector
Non-operation -25 to +85°C RJ45 +24V
Humidity
Operation 5 to 90% PIN DATA DATA&POWER
1 data Negative out
2 data Negative out
3 data positive out
4 data positive out
5 data positive out
6 data positive out
7 data Negative out
8 data Negative out
 |
